Search results

rebuilt the brakes on both sides last night and all is well. Must have been a bad wheel cylinder or maybe the original springs just didn't have enough strength to close the brakes back in....

I am selling my 1965 mustang coupe. Car has a 289 2bbl with an automatic transmission. Interior was completely redone in the late 90's and still looks very good. Car has new tires and rear brakes. Runs good, drives great. Only selling because I currently have three mustangs and just do not...

not really, mostly like it is wearing more in the center of the shoes and not so much around the edges....... very strange

Both shoes are not evenly worn. No recent work, just got it out after winter and this started.

Makes no difference with the drum on or off or running or not running. I can spin everything freely with my fingers. The drum does not look bad and no uneven wear. Brake oad wear does look un even though.

Hi everyone, need some serious help diagnosing an issue on my 65. If I take the car for about a 10 mile drive something on the drivers side rear wheel is heating up enough to cause minor smoke. By the time I pull everything apart I cant tell where the smoke is coming from. The brake drum is...

Careful. 92-93 seats are not the same. I think they would fit just fine but they are not the same. Actually I think they are more comfortable.

Are those 2005 gt wheels on your car? I like that, never seen it before.

Ready to roll

Looks clean

So the bearing would stay silent in a straight line and be quiet until they warmed up? I'm just going to have to replace them and see, I'm out of ideas so I think the axles are coming out.

I can tell you I just got a 92 summer edition feature car with 4,900 miles on it my father in law bought new and sat in a barn under 2 covers since 94. My engine bay looked terrible. It's slowly getting up to par though......

Springs are definitely there. I know how to adjust drum brakes but that's about it so I'm just basically looking for anything obvious wrong. Everything I have worked on has had disc and I have never had a need to pull the drums on my other fox body so I'm figuring this out as I go

I had the cover off and everything in the pumpkin looks new. Next stop is pulling the axles I guess. What would go bad on a brake shoe and cause a sounds like that?

So I changed the fluid and added the friction modifier and did some figure eights but so far no change. Seems like more of a rubbing sound bit can't find anything rubbing. Definitely coming from both sides though. 7991LX, what kind of sound did you have on your bearings? We're they quiet in a...

Jacked up if I spin the wheels it is silent. Sounds just fine. I'm going to get the the gear oil and friction modifier tomorrow and see if a lube change helps

Definitely a low speed groan when turning but it seems to me that it is coming from the outer most point of the axle. The wheels basically. I don't know if the noise transfers there or what. I am going to Service the rear fluid as my next step and see what happens

So..... how will I know the bearing is bad?

Guys I need a little help. My wife recently got a 92 LX 5.0 SE, the red one with the white wheels and white top with only 4,000 miles on it. It has sat in a barn for the last 20 years with an occasional around the block drive. Everything on the car is perfect except for when I take low speed...

Thanks for the tips guys. My existing gaskets have been on the car for about 10 years or more and a lot of miles so they held up for quite some time. I was just really hoping I didnt have to loosen the header from the H-pipe, I worked on a car once before that once I loosened the connection I...