Search results

  1. 8

    Changing axle ratio

    Thanks for the replies. Does anyone know any good mechanics to do the gear changeout in the Tennessee or Alabama areas?
  2. 8

    Changing axle ratio

    I am getting ready to order some 4.10's for my 08 GT. The car has 12,000 miles on it. What are recommendations on bearing replacement and rebuilding the traction LOK? The site that sells the gears recommend the bearing replacement and traction LOK rebuild. Are most people replacing all of these...
  3. 8

    pcv hose

    I went ahead and cut the factory hose off and used them. Before I did I called a local dealer (not the one I bought the car at) and had them order one. $25 for that hose! I want to be able to put the car back to the exact factory look incase I have to take it in for engine work.
  4. 8

    Underdrive pullies

    Do you have to retune the 05 mustang if you install underdrive pullies? Anyone that has tried them how much difference does it make?
  5. 8

    pcv hose

    Well I installed the cai and wow! If anyone is trying to decide if it is worth the money, it is. Gives the car a lot meaner sound too. It goes good with the flowmasters.
  6. 8

    pcv hose

    I got my airaid cai in and getting ready to install. They sent a different pcv hose to use. You have to cut the original off the fittings. I was wondering if anyone knew a place on the internet where you can order these fittings. I would like to keep my factory stuff intact and just get two new...
  7. 8

    Rear-End Gears?

    What kind of rpms do you run in 5th gear at 55 mph with the 4.10?
  8. 8

    hesitation around 2800/3000 rpms

    Took mine in, me and the tech hooked computer up and drove it down the road. He said it was the runner control in the intake opening causing the hesitation. He called ford and they said it was normal, I don't buy it though. I am going to find another five speed and drive it to compare notes.
  9. 8

    hesitation around 2800/3000 rpms

    Could it be a flaw in the rev limiter?
  10. 8

    hesitation around 2800/3000 rpms

    Mine does it the same with the ac on or off. I have an appointment tuesday to take to the dealer and let them diagnose the problem. I will post back what the problem is.
  11. 8

    hesitation around 2800/3000 rpms

    Even with the hesitation it still ran good enough today to smoke the hell out of a LT1 comaro.
  12. 8

    hesitation around 2800/3000 rpms

    I have a 05 gt, 5 speed manual. I noticed today that around 2800 to 3000 rpms there seems to be a slight miss or hesitation. It is almost as if you let off of the accelerator a bit. It is more noticeable if you are slowly accelerating in first gear. The car has 1900 miles. Has anyone else...
  13. 8

    Rearend problems?

    Finally got my 05 gt I have had ordered for 9 weeks, mineral grey, leather interior, interior upgrade package, 5 speed, shaker 500. I have 120 miles on it and I noticed it has kind of a knock in the rearend when you shift gears and let out on the clutch. Has anyone else experienced this? :bang:
Top Bottom
Back
Forums
Menu