Search results

So after along wait I am getting ready to finish assembling my motor.I came across a good deal on edelbrock rpm 2.02 heads and cam is 7122 edelbrock.I calculate 9.5 comp. I am a little worried about using the 2.02 heads as I worry about losing low end torque. I have a wc t5 and plan on btwn...

I just started to install a pair of gw adj. strut rods and I think they may be too long. I made a rough measurement from 2 points and the new rods are going to move the lower arm back by 1/2 inch when adjusted to minimum length. I would have expected them to have the ability to adjust for both...

I lucked into complete versailles rear disc set up less 9" housing. as far as I can tell it should bolt onto my 65 8" housing . Anyone know if it will or what problems I may have. I have discs in front and know I have to change m/cyl to all disc anything else?

I am working on what is supposed to be a set of 73 pantera heads.What has me stumped is that they have the large 4 bbl int/ex ports but are using the small 2bbl size valves (ex. 1.655" int 2.040") they are open chamber heads casting #D3ZE-AA. Everything I have read tells me all 4bbl heads...