Search results

  1. 18mustangs

    Accu 75 added...spooky looking plugs !!!

    I am very interested in the dyno results. I often wanted to know if the old 65mm vs 70mm argument was true, and if 75mm being too big was a wives tale too. Enlighten us Andy! Tim
  2. 18mustangs

    Accu 75 added...spooky looking plugs !!!

    LOL, there you go again introducing facts and logic into the argument again Hissin! :hail2: My mounts are the stock mounts...knowing Andy he's got some high speed aftermarket mounts! :nice: Tim
  3. 18mustangs

    Accu 75 added...spooky looking plugs !!!

    Good luck at the dyno Andy! Keep us posted on your results. Did you feel any differences going from a 65mm TB to the 75mm, and noticeable loss in torque or responsiveness, any noticeable up top gains? I guess your experiences show each car is different because the Cobra plaque and the...
  4. 18mustangs

    Ignition System upgrade

    :cheers: I'm with you. My MSD 6AL and MSD Pro-billet distributor made the car run smoother, feel slightly stronger, and make my exhaust smell less rich (unscientific nose test). I was happy with the results over all. Tim
  5. 18mustangs

    Accu 75 added...spooky looking plugs !!!

    Andy, are you running a taller hood? With my 93 Cobra intake the PCV tube on top of the fox TB is almost rubbing the hood without an intake spacer and I recall you running those VCs with the old cobra upper a while back. Tim
  6. 18mustangs

    BBK Throttle bodies any good?

    I've noticed no diference in quality between my SN95 FMS 65mm and my Fox BBK 70mm. Both were quality pieces, no sticking or other problems. Tim
  7. 18mustangs

    cruise control cable

    Yes it is a different cable than the Foxes. The attaching point at the TB is differnet Tim
  8. 18mustangs

    do i have an e-303 or b-303 cam???

    Where does you car have its idle set? My car idles a 650 RPM and really sounds like it has a cam...no vacuum leaks at all either! :D Tim
  9. 18mustangs

    do i have an e-303 or b-303 cam???

    I really begin to feel the power at 3000, FRPP says peak torque is 3300 RPM, peak HP is 5100 RPM which is about what I feel with the old SOTP meter. Regarding idle being lumpy or lopey, ford classifies the E-303 as good idle while classifying the B-303, F-303, and X-303 cams as fair idle...
  10. 18mustangs

    oil smoke, but how serious??

    Are you sure it's coming from your exhaust? Check under the car for leaks. I just had a problem where I would stop and would notice smoke, my driveshaft u-joints went vibrating the car causing my output shaft seal to leak which threw tranny fluid onto the h-pipe causing the smoke. I replaced...
  11. 18mustangs

    smells bad in car

    Once again Hissin is on to something! I used to have a permanent 93 octane cologne when I ran my o\r h-pipe daily, now that I run my catted h-pipe daily it's gone. That cats were the only change. Tim
  12. 18mustangs

    do i have an e-303 or b-303 cam???

    Guys, the B303 is a more radical cam with regards to duration than the E303 and hence has a lopeier idle than the E303. The idle is attributed to duration and not lift or stock 93-95 cobras would sound like hey have a cam with the .479 lift (with the 1.7s).
  13. 18mustangs

    sn95 fox body transplant?

    FRPP actually has a TPS harness adapter for about $13 that allows an SN95 TB to be used in a fox with no modification so that isn't the hard part. Tim
  14. 18mustangs

    full length or shorties?

    I've run them both and the long tubes are the way to go my friend! Tim
  15. 18mustangs

    Will GT40 Manifolds With Egr Spacer Built in fit??

    Darn right, I did it and would never want to go back to the SN95 setup. It was more involved than a standard intake swap, but the fox setup is much easier to work with IMO. Tim
  16. 18mustangs

    o/r pipe = poor gas milage

    :stupid: Me too. I think less restriction would equal better scavenging and better efficiency.
  17. 18mustangs

    IAC restrictor plate installed!

    RJ, first thanks for a quality product, it was very well made. I also noticed a slight change in my exhaust note but thought I might be imagining it. My idle isn't hanging with the plate noticeably anymore, perhaps my car's learned the idle. I too noticed the improved response between shifts...
  18. 18mustangs

    IAC restrictor plate installed!

    I just installed this plate on Sunday with my Fox TB conversion and it works great! There is noticeable throttle response improvement, noticeable SOTP improvement. The car also has better manners at low throttle than it did before. However I didn't have a hanging idle before, and still really...
  19. 18mustangs

    ssi intake

    Get a Steeda PCV oil seperator or make one yourself and it'll solve the oil in the upper intake problem.
  20. 18mustangs

    shaker hood scoop

    They do make a shaker for our body style that is functional, just not out engine...it fits 96-98 and it's from Classic Design Concepts. I know it's splitting hairs, but it looks good and is all prefabbed. Tim
Top Bottom
Back
Forums
Menu