Search results

You should definetly get it dyno tuned. You get some power from the performance tune in the Predator but a good tuner that knows what he's doing can get more out of it on the dyno. Also. Different dynos will read differently. As far as the numbers, it's not too far off in my opinion. My...

I have the Steeda STB on mine and I noticed a difference but only on tight fast turns. You'll notice the full length sub frames more.

Be generous with the grease. Don't want noisy CAs.

Or. Here's some more info. Visit AboutUs.org for more information about RPMOUTLET.COM AboutUs: RPMOUTLET.COM Registrant:Make this info private RPM Outlet Inc. 13313 Redfish Suite #104 Stafford, TX 77477 US Domain Name: RPMOUTLET.COM Administrative Contact , Technical...

Here's a thought and just my $.02. MM&FF states somewhere (& i forget where) that they stand by the vendors that place ads in their publication. IT also stated that should you have any issues, to contact them (MM&FF) and let them know. I'm not saying that MM&FF will ship you your part...

As stated before. This intake really makes a difference with a SC'd application.

Bump!! Big T. What did you end up doing? I'm having the same issue. I just had the mid length coated headers installed and my steering shaft just a tiny bit. I also don't want to dent the header. Any suggestions on this please? Thanks.

Although i do not have any specifics, i did hear about a similar issue with someone else's GT. THe problem was under the dash. There was a peice to replace on the steering column. THe cost was right around $30.00 I know that that was very vague, but it's the best I got from what I heard...

I have the Steeda 3 point STB. I felt the difference right away but only on tight turns. It did not affect the handling on long hard curves. My $.02

Not sure if this has been posted yet I think it's real important to know about. Concerns the safety of your home and family. http://www.youtube.com/watch?v=hr23tpWX8lM

:Word: Subscribing.

When you put the jack away, don't close it completely. You have to leave it half way open. It has to be set so that when you fold the bar across that jack, the circle in the middle has to lay flat. Then just put the jack in and line that hole up with the bolt sticking up from the bottom of the...

OK! How the hell is anyone supposed to concentrate on the damn intake with that animal of a woman standing right next to it?! Seriously, i clicked on the 3 images just check her out, closed the page and then realized that I didn't even glance in the intake's direction. Sorry, I am of no...

+1 on the flywheel. Either re-cut yours or get a new one.

I would say so. That's how I'm gonna be doing it.

I have heard that regular tranny fluid can cause this problem in cold weather. You may want to switch to synthetic. Maybe Royal Purple? Good luck.

MM&FF just did an install with Crower cams on a 2V in the new issue. They said they got around 50HP, but the motor was already modded. You may find it of some use.

If you think the shifter to be too low, Steeda sells a Comfort Pro Shifter Handle that brings the handle closer to the driver. I have it on mine along with the Tri-Ax and I like it alot. The Tri-Ax alone was uncofortable for me(too long of a reach), so I added the handle...

http://www.motorcraft.com/home.do

I have to kinda agree with some of you. Based on some of the other numbers I've seen on this board, it does seem high. But like i said before, the car was real cool and it was only one run. :shrug: BUt I also don't mind showing the dyno sheet. :D I should be going back soon to get it dyno...