Search results

  1. F

    Time to change the spark plugs...

    The deal is that the plugs are a very extended tip design with a alose fit sleeve after the threads. Once you see the new plug you will understand. Apparently the design change was necessary with the 3 valve head design. My opinion is after the first plugs come out you probably wont have any...
  2. F

    Time to change the spark plugs...

    BE CAREFUL. The plugs have been known to break off in the head. I have seen the dealer communications from ford about this before I quit working for them. The last I heard the plugs like to sieze in the head. They are a new design and look quite different from conventional plugs. They are...
  3. F

    Anyone running WMS ramair kit??

    I did the wms intake without a tray for now. there are gains and it does work and look good. No tune needed on my automatic and my wife picked up on it being faster right away.
  4. F

    2006 GT bad rear clutches

    the problem has been arround for quite a while. It is nothing new. I used to replace explorer 8.8 inchclutch packs quite often for a chatter condition under power and turning. this could appear in any vehicle with clutch type posi units. Hopefully the new parts are better. I never had any...
  5. F

    WMS intake vs CDC Shaker

    I too installed a wms intake without a tray(I do plan to get one). The car was never dynoed however I did do a g-tech run befor and after. I tried to eliminate variables as much as possible, same road same temp approx same lauch. Before 0-60 5.28 after 5.20 and the quarter mph gained 2...
  6. F

    Help - P0430 OBD-II Trouble Code

    the rear o2 sensors have to be working to set this code because they are switching indicating that the cat is not working at the minimum threshold. If it were a stock system it is almost always a bad cat. Now assuming that there are no leaks in the exhaust system and the cats weren't dropped...
  7. F

    Alignment help

    I do alignments for a living. Honestly either way would be acceptable as long as the person elongating the holes could do it without hacking it up but MY personal preference would be the camber bolts if for no other reason other than you can adjust the front end very accurately in very small...
  8. F

    R&R rear differential

    from my experience 3-5 hours should be normal if you dont end up needing side shims. otherwise it probably will turn into an overnight situation because most dealers refuse to stock them because they eat up a lot of inventory cash. also there is no way of knowing which shims you will need...
Top Bottom
Back
Forums
Menu