Search results

I have the following parts to setup a hydraulic clutch. I used the same kit for a T5 conversion on my '66 and have loved it. I have a second set of these parts I had intended to use but no longer have that project. CNC 711-3/4 master cylinder without resivour - $85 new CNC 305-B push slave...

This is a stock z-bar from a '66 which I modified to improve the movement and tighten up the slop in the original design. I switched to a T-5 with a hydraulic setup and don't need this any long. With a simple modification to the clutch peddle, it drops right in. The bar going through the...

You only put one end on and I'm sure it is the distributor end as the other is nicely molded in place. I also got the 45 degree boots which work great for keeping them off of the headers. It is a fairly simple process of stripping the wires and crimping the end on. I did not have any special...

I went with Taylor wires which you put the ends on yourself so you can make the length custom. They are held into place with separators from Made-for-You. I was very happy with the setup and it is exactly the look I was going for, clean and simple. Good luck IMG_5210.JPG photo - longman41...

This is a used flywheel which has been freshly resurfaced. It is listed on ebay. http://cgi.ebay.com/ebaymotors/Hays-164-Tooth-Billet-Aluminum-Flywheel_W0QQitemZ280402744132QQcmdZViewItemQQptZMotors_Car_Truck_Parts_Accessories?hash=item41494e5344&_trksid=p4506.c0.m245 Item # 280402744132

Yes, I used existing rods. I chose to drill 3/4" holes and bolt them into the frame. I put the holes as close to the original mount point which is maybe an inch or slightly less. I used spacer sleeves on each side of the heim joint and off-set it a little to the outside to ensure clearance of...

I did a single aluminum pipe for the front line on my Stealth intake. It has a rear water cross-over so one of the two hoses connects back there. Here's the only picture I have handy showing it. I think I got the pipe from McMaster, but don't recall for sure. I just sanded it with some 1200 grit...

Here's an option for an adjustable strut rod that's pretty cheap to make. I'm really happy with mine and the other suspension changes I made.

I've got a RUG-AG Toploader transmission for sale. It's a 28 spline Close Ratio. It's in very good condition and was working flawlessly when I pulled it. My pressure plate went out and I'm converting to a T5. This Toploader was rebuilt by the PO of this car and had new bearing and blocking rings...

I've got a RUG-AG Toploader transmission for sale. It's a 28 spline Close Ratio. It's in very good condition and was working flawlessly when I pulled it. My pressure plate went out and I'm converting to a T5. This Toploader was rebuilt by the PO of this car and had new bearing and blocking rings...

Here's a great source for wiring diagrams Midlife is on the Vintage Mustang forum all the time. He's got some really good diagrams you can download. http://midlife66.com/wiring/wiring.html Good luck, Warren

FS: Hays Billet Aluminum flywheel 164 teeth(used) I'm not sure what this is worth, but thought I'd give it a shot here before Ebay. It's used and may need a new surface or you may be able to lightly re-surface it. I have not found out what that costs, but I'm sure someone here knows. It...