Search results

  1. the98stang

    Opinions On A 2013 3.7 V6 Build

    get the v8 lol....you will thank me later
  2. the98stang

    Oil Consumption

    a quart low? Something is not right. either you have a leak somewhere, or oil is burning past the piston rings/valves. Take it to the dealer.
  3. the98stang

    Clutch Issue?

    did you put the factory size gears back in, or a different ratio ? the 07s had a TSB for the clutch....do you know if yours was ever replaced? TSB 08-16-4 SHELBY GT500 - CLUTCH DRAG Publication Date: July 28, 2008 FORD: 2007-2009 Mustang ISSUE: Some 2007-2009 Mustang Shelby GT500 vehicles...
  4. the98stang

    2011 Shelby With Super Charger and NOS

    Do NOT run a dry kit, you will blow the motor. Get yourself a good wet nitrous kit. A 50-75 shot should be fine. All the safety stuff....WOT switch, bottle heater, colder plugs, etc PS- I hope your rods and pistons are super strong !! lol
  5. the98stang

    Clutch Issue?

    Very hard to diagnose without a video clip. If the clutch is working fine, I wouldn't worry about the noise ....Fords are noisy :)
  6. the98stang

    cobra supercharger on a GT

    i paid $2000 for my vortech kit which included the FMIC, injectors, and everything else besides the fuel pump which was $100:rolleyes:
  7. the98stang

    my GT needs more ponies..

    410 gears, intake, exhaust for starters
  8. the98stang

    Rear end question, asap

    time for some nice aftermarket axles and slicks!
  9. the98stang

    Question about Compression Test and Spark Plug Removal

    also, if you use antiseize use VERY little, and torque all plugs to 14ft lbs! compression should be within 10% of eachother.
  10. the98stang

    Motors eating coolant, and bad miss

    you have to do a leak down/pressure test to find out where the coolant is leaking from
  11. the98stang

    oil problem

    rings are probably worn, and the nitrous won't help. do a compression test and make sure everything is OK. You could use a thicker oil such as 10w-30 to prevent ring blow-by.
  12. the98stang

    Motors eating coolant, and bad miss

    do you have the old plastic intake manifold with the plastic coolant crossover? If you do, it could be cracked and leaking coolant into the cylinders or elsewhere. Easy test would be a leak down/pressure test. If the intake is cracked and coolant is getting into the cylinders it may cause the...
  13. the98stang

    Need advice on tuner for modded 96 Cobra

    I doubt it needs that much tuning. if you wanted cams you could tune the car yourself with SCT Pro Racer....it's fairly simple
  14. the98stang

    Head Gasket...Need Advice..

    Modular Mustang Racing MMR 600 shortblock for $2500...