Search results

Still for sale.

Hey Jcole, Thanks for your interest. I can ship. I will pm you soon.

I am in concord, ca I am selling an American thunder cat back for 87-93 GT mustangs. I also have a Mac off-road x ,and h pipes. Both for shorty (stock length) headers. I don't have pictures of the h an x pipes because they are in storage but can get pics if requested. The cartback has som...

The stock style sol. should mount directly in the stock location, on the fender apron. What about the clutch safety switch? Maybe its not adjusted propery, I think that they are adjustable. I think there is a positive and negative on the solenoid terminals, maybe the wires going to it are on...

^^^ agree Check the right wires; black and green

With the ignition on and engine off, open the throttle with the gas pedal then release it, this should reset the tps. I read somewhere that the tps is self adjusting on our cars and that there is no need to set it with a dvom. I've tried this on my car to see if it works, and i have reset my...

Also don't throw money at it, first check everything, make sure it is in its proper workong state by testing it, otherwise you're just wasting time and moneys.

Bad ground can be the problem, and if your solenoid on the fender is not wired right the starter won't disengage.

Today, i tested my switch, and i pulled back on it while it was plugged in, and the lights went off. I thought, my switch is broken, but upon further examination of the switch i found that the plastic cover on the switch, has little tabs, which were broken. Those tabs had gotten stuck in the...

Yes, it is a '92 gt vert,and the car doesn't have any fogs, they were removed by the previous owner. I will test my switch tomorrow. Thanks for the links, my headlight harness had some bare wires taped together with electrical tape too.:nonono: so, i'll be getting a new one along with the...

Will a broken headlight switch make them stay on? I just took out my instrument cluster to replace a burnt out bulb. After i put it all back together, and plugged the battery back in, meanwhile my headlight switch was off, my guages were lit up and my door open bell was ringing. I unplugged the...

mine would stick like that with a mini starter, i had to get a new starter. i woulkd check the solenoid wiring too, most of the wires go on one side, and i think there is only one wire on the other that goes to the starrrter itself. "edit":just saw the other post

my pedal is stiff and always has been pretty stiff. i have the mm quad and bbk fw adjuster. i had the same problems as you, but the plastic on my cable broke where it meets the bell housing, it was adjusted too tight. Another time, the outer part of the cable melted because it was too close to...

email sent

ttt

is it a new motor? when i rebuilt my engine i left some oil in the cylinders so nothing would rust in the bores and forgot about it and when i started it up the first time all the left over oil in the cylinders burned off making my plugs fouled, i had to clean them with some gas and a wire brush.

2 chamber flows A.T. gt 2.5+mac o/r h* north california* i am selling a 2.5" flowmaster AT (2 chamber) catback kit for 87-93 gt stangs. i also have a 2.5" mac offroad h-pipe for sale. this setup on my car was loud and sounds good. i would like to get 300$ plus shipping for both or can sell...

have you pulled codes or anuthing. you might have developed an exhaust leak have you worked on the exhaust lately

that sucks ass, your valves are toast youre kind of lucky nothing happened to the rest of the motor. if the timing chain slipped, couldnt that be the cause of the valves hitting the pistons, because of the camshaft slip making the valves stay open longer in relation to the crankshaft and piston...