Search results

  1. 9

    car not starting, plug wires marked before removal HELP!!!!

    I have a 90' 4 cylinder, single plug motor. I checked the plugs today and now my car will not start. It sounds like, when it does start, that the plug wires have been crossed, but I marked the wires before I started. Even the diagram in my Hayne's manual proved I marked them right. It felt like...
  2. 9

    break light stuck on

    I have been having the same thing happen to me. It is a little annoying, especially at night. My instrument panel dosen't always come on, so having that one single light on is a little distracting. It happened after I had the e-brake handle pulled up, and accidently bumped it while removing the...
  3. 9

    done a search but couldn't find what i need help with

    It was pretty easy. Now I need to drill the bung and then I will get it hooked up, and should be done. Thanks for your help.
  4. 9

    done a search but couldn't find what i need help with

    me and the tech at the exhaust shop I went to figured it out. If I had the tools, I would have done it myself to save some money. But the best part was he didn't charge me a thing. He even gave me a clamp to hold the smaller pipe inside the larger one. If the egr isn't at fault, I don't want to...
  5. 9

    done a search but couldn't find what i need help with

    I did some searches of the EGR, but found nothing related to my problem. I put on a Ranger manifold a few weeks ago, and couldn't re-use the egr pipe from my car or the rangers. Neither would reach. So I am running without the egr being fed by the manifold. I replaced the stock o2 sensor sense...
  6. 9

    installing bosch o2 sensor, need wire diagram

    Thanks for your help. My eyes just couldn't read the fine print in the manual I have. I got my o2 sensor connected to my car properly now. No more "check engine" light. However the car still surges and sometimes dies, or almost dies. I can be in 2nd gear, and it surges so bad, the wheels chirp...
  7. 9

    installing bosch o2 sensor, need wire diagram

    After doing the Ranger header swap, my o2 sensor connector wouldn't reach the connector in my car. I tried to cut the connector off (the one off my car, not the one coming off of my o2 sensor)and splice in about 6 extra inches to each wire so the connector would reach. But I lost some of my wire...
Top Bottom
Back
Forums
Menu