Search results

Recently got an '89 5.0 vert. All 100% stock original except 3.73s. I noticed on a long drive, the floor just under my left foot really heated up, like it was coming off the cat or the exhaust is getting super hot. Everything runs OK, not overheating, but I'm concerned the cat is messed up or...

1989 Mustang Notchback Coupe 5.0 LX for sale 5 speed manual T5 transmission Ford GT40P heads (from Explorer, professionally cleaned, milled, valve job and new springs) Ford GT40 (Explorer) intake Ford racing headers Offroad H-pipe (car no longer need to get emissions tested, but passed even...

I noticed a mild coolant leak a couple weeks back, and traced it to the hose going from the metal heater tubes to the inlet of the heater core. Tightened the clamp up good, and leak was solved ! Just tonight driving, I got on it hard, like 6K rpm and the hose exploded, lost coolant, had to call...

Has anyone used these ? I can't stand my dronemasters, I never drive the car because of the noise. The Dynomax VT are supposed to cut out low throttle noise and drone very well, just wondering if anyone has used them, and if so which ones ? There's the 17159 and 17959, either should work for...

My charging has been weak ever since I bought the car, like dimming headlights at night. Last night I was idling at a light and the voltage was LOW, like near the red, so I'm reving the motor up to about 1200 rpm to maintain the voltage at the middle. This was working like normal, then suddenly...

http://seattle.craigslist.org/oly/cto/4652776741.html They're willing to trade it for a Corvette !!

I had installed Crane 1.7 ratio roller rockers when I did my GT40p heads a while back. Problem is, even after re-checking the torque/install on them several times, I could never get them to be quiet, car always sounded like a loud sewing machine and I couldn't learn to 'accept' it. So today I...

Just went to the track which unfortunately was ridiculously busy being it's the first decent weather they've had for a test n' tune event. Spent 5 hours there got in 2 runs... lots of waiting but got to see some nice rides. The first run I spun bad, but the 2nd I hooked ok and went 13.82 @102.3...

Can I pass emissions with the following setup ? GT40p heads Explorer Intake Stock HO Cam w Crane 1.7 Roller Rockers FRPP headers 73mm MAF Offroad H-Pipe Flowmasters

Myself I'd say gears. Everybody likes to do gears because it gives you a kick in the ass. In my experience, after the fun of burning out in 2nd wears off, you realize the car really isn't that much funner to drive, and the short gears become more of a pain in the ass. I had a Notch with 3.55's...

Has anybody used these ? They have new sets on ebay for $107 shipped. I need rockers for my gt40p heads and these are clearly cheaper than most. Are they any good ...

Has anyone had experience running just the PS underdrive, while leaving the crank pulley at stock ? Is there any change in power or steering response ? It's offered by this company on ebay...

I'm getting ready to swap heads and intake, but I have a mildly slipping clutch so I'm considering doing that really soon too. Is it better to do the h/i from the top, then drop the tranny later on. Or would I be best off to just pull the motor/tranny as a unit and do it all that way ? I'm...

When checking for codes i found that my neutral gear switch in the T5 is not working (had to hold clutch the whole time). I checked it with a meter at the pigtail and sure enough it is not closing contact regardless of shifter position. So, i wouldn't care if it only affected the code checking...

Ok so according to the pic on my radiator shroud this should be a legit setup. Has anyone done this and can anyone tell me the belt length that will work for this ? In the pic it shows it with the AC just bypassed - so it follows that I can have both the AC and smog bypassed and use the same...

My present ride when I bought it had an aftermarket K&N cone filter, installed just direct strapped to the mass air. I went on ebay and picked up the stock air box. Threw it in with a fresh new paper fram filter. Butt dyno picked up like 15HP. Thoughts?

I'm pretty new to this area (north end of Seattle)... try to get out on my dirtbike as much as possible. Does anyone have any suggestions for descent places to ride fairly close by? And of course I'm always looking for more people to ride with, send me a message if interested Dave

I'm in the middle of doing my ac delete kit from latemodel resto, and the bracket doesn't come with instructions and I can't figure this thing out!! Can someone fill me in ?? Do you retain the original bracket in addition to the new one ?? Pics ???! Thanks

Just remembered this one and thought you might like it... see if you can spot the 2nd gear "chirp" <a href="http://vids.myspace.com/index.cfm?fuseaction=vids.individual&videoid=798984687">Burnout</a><br><embed src="http://lads.myspace.com/videos/vplayer.swf" flashvars="m=798984687&type=video"...

I have a strange wiper problem where they vary the travel distance constantly. Generally at low / delay speeds they will only travel about 3/4 of the "full" amount before returning. At high speed however they do travel the full distance. It seems that possibbly the timing device or switch is...