Search results

Very, very sweet ride! Congratulations .

Take it to a good welder. My front left seat bolt had ripped out of the floorboard too and there was about 3 square inches of metal still attached around the bolt. I took it to a local, experienced welder and he bent it back into place and welded it. Fixed it right up. No problems since...knock...

+1

How did the 95 cobra R fit?

Don't think it hasn't crossed my mind to sell them. Why don't you just buy the replicas?

One thread should be enough? I started this new thread to specifically call upon the help of 93 Cobra owners by use of the "93 Cobra owners...Please help" title. Thanks for the LRS link. I'm trying to verify the information contained in the 93 Cobra specs link in my first post (the part you...

I really, really need some help concerning 93 Cobra front rotors. Would somebody be so kind to measure the total height of a 93 Cobra front rotor as if it was laying down flat. I've read where they have a 3/4 inch taller "hat" on them, compared to a GT rotor. I'm needing some extra tire-to-shock...

Yeah, I'm already running 3/4 inch spacers in the rear. Will someone give their honest opinion on these rotors in this link...

Ok...I checked at Autozone. The wheel bearing part numbers do match. Can someone please outline the procedure on swapping rotors? I've looked in my Haynes manual and had very little luck on swapping rotors. Thank you so much.

I'm looking for a little extra clearance with the oem 93 Cobra wheels on my 90 GT. I've read where the Cobra rotors have a taller "hat" on them. Will the 93 Cobra rotors directly work on a 90 GT, or would I have to change something else also? Thanks for your help.

Ok...here's the deal. I took my 93 Cobra wheels off of my wrecked 90 GT and installed them on my good 90 GT. I never had any major issues with them on the old car, except maybe some minor rubbing on the inner fender shield in a tight turn. When I bought the good car I put the cobra wheels on...

I'm sure there are alot of good cams out there and even more opinions. But I can testify to the B303. It has a fairly aggresive idle. Nothing too wild, but definetly a head turner at the gas pumps. Once a guy came up to me and said "she knows she sounds good" lol. The main thing I like about the...

I absolutely love my FRPP B cam. Good low end torque and pulls very hard from 4000 rpms and up. I have 373 gears in rear though. Whats yours?

I just bought a new Duralast water pump. Very pleased with it. No leaks. Lifetime warranty. I recommend rtv on the gasket (on any brand)

I belive you're right. But how in the world did it break? Isn't the bearing retainer a one piece that bolts to the front of the tranny? Or is it a 2 piece?

We were removing the bell housing when the throwout bearing and a mysterious piece of steel (3 or 4 inches long and cylinder shaped...hollow on the inside) hit the floor. Can someone please tell me what this piece is? Thank you so much for any help you have to offer.

Any more opinions?

I was wondering how far to drive the pilot bearing in during replacement. It's going in a 90 GT. Thanks for your help.

Is the Redline MTL ok to use in a T5 transmission. Is it Mercon III compatible? Thanks for your input.

Are the brackets part of the headers? I have BBK long tubes if that matters. I don't remember seeing any bracket on or near the headers.