Search results

  1. wythors

    Lower Intake Manifold Coolant Leak

    Where are you located?
  2. wythors

    Msd 6al Digital Sucks!?

    Because it comes with a cool sticker.
  3. wythors

    89 Vert Open Trunk From Inside? And Another Question

    These are the weather strips (dew wipes) and these and these are the moldings. Note: You might check with your local Ford dealer. The last time I bought these parts, the dealer was actually cheaper than 50Resto and they were readily available. If your car had the interior trunk release to...
  4. wythors

    Saleen 96 Saleen convertible

    But what is the bumper number?
  5. wythors

    Flowmaster 3' Inch Delta Force Vs Slp Lm 1s

    Bassani catted X-pipe. The first SLP system I installed was on my wife's old 96 Cobra with the factory front pipe on it. That thing sounded awesome. She'd get stoplight compliments on it almost daily.
  6. wythors

    Flowmaster 3' Inch Delta Force Vs Slp Lm 1s

    It does?
  7. wythors

    Saleen 96 Saleen convertible

    Give me the last three digits of the VIN and the bumper number.
  8. wythors

    Black Accent?

    Hopefully, the flat black thing will quickly go the way of 13-inch, reverse-offset, gold wire wheels, slammed mini-trucks and gold trim on Cadillacs. Leave the stripes to the 4-cylinder crowd.
  9. wythors

    Control arms on a budget?

    Do yourself a favor and research UPR's reputation, as well as Maximum Motorsports' before you spend your money.
  10. wythors

    Control arms on a budget?

    Summit control arms are the same cheap offshore stuff sold by Granatelli, 50Resto, Blue Oval Industries, etc, etc. A couple of years back there was a thread on here with pictures of a freshly installed Summit LCA that had completely sheared off at the rear bushing on the first hit on the drag...
  11. wythors

    Help With Removing Rear Spring Spacers

    Ummm... All you've gotta do is raise the car and support the rear axle on jackstands. Then support the rear of the control arm on the side you want to pull the spring out of with the jack. Remove the bolt holding the lower control arm to the rear axle and slowly lower the control arm until...
  12. wythors

    88 t-top production numbers are in

    Do you guys realize that this thread is six years old?
  13. wythors

    Rear Springs Isolator's

    The uncompressed thickness of both isolaters combined is about 5/8 of an inch. I honestly couldn't tell a difference when I did it.
  14. wythors

    Introduction... Longtime Stangnet Member Coming Into The Fox Forum

    Welcome from another old guy named Dave.
  15. wythors

    Looking For A Proven Cleaner

    If you do a little looking, you can probably find someone selling one local for next to nothing. I gave away or scrapped the last three I had.
  16. wythors

    Difference Between Aluminum And Steel Flywheel?

    I had an aluminum flywheel for about two weeks. Never again. Unless you drive it like you stole it all the time, it's not worth the money or the time for the marginal gains in percieved power gain. As stated above, they suck in traffic.
  17. wythors

    How Would You Rate Your Mustang Experience?

    I could get up tomorrow morning, drive over to the Ford dealership about two miles from my house and drive home in my pick of any Mustang on their lot, if I so chose. BUT, the new Mustangs don't do a thing for me. They're just a car. If I was to buy a new muscle car, it would probably be a...
  18. wythors

    How Would You Rate Your Mustang Experience?

    Every winter, after my convertible has been off the road for about three months, I start to think that I should probably sell it. After all, I only put about 1,000 miles a year on it. Then, on the first nice day it starts up on the first crank, I drop the top and I punch the throttle. As I...
  19. wythors

    Painting the upper intake?

    Okay, here's your guide. Pull the rubber boot off the throttle body. Carefully disconnect the throttle cable from the bottom of the throttle body. Use small visegrips or some other clamps to block off the coolant lines going to the EGR spacer and disconnect them. Remove the electrical...
  20. wythors

    Painting the upper intake?

    Seriously? Buy a new upper plenum gasket, remove the four screws holding the intake plaque on, remove the six bolts and go to town with it.
Top Bottom
Back
Forums
Menu