Search results

  1. P

    SOLD Fs: Black 2003 Cobra Vert /w 39k Mi (houston/tx)

    Selling my '03 Convertible Cobra /w 39k miles to fund the down payment on a new house. Modifications listed below. The car does a few rock chips on the hood (in pictures). I'm looking to see if this car will sell without taking it over to the paint shop and having the hood painted. Car is...
  2. P

    Stuff 2x twelves in sn95

    Got a '02 GT /w mach460 sound system in the back. Trying to find a box to allow at least 1cu ft of space for each twelve i'm trying to shove back there. Anyone have any experience trying to get two in there? Thinking of trying to fit two seperate boxes in there, or just return my kickers and...
  3. P

    Need new shocks /w Eibach pro kit?

    See a lot of people buying new shocks and camber plates /w the sportline kits... do you need either of these /w the pro kit? I'm looking to only drop my car 1 - 1.5 inches to get rid of the 4x4 look. .. or mabey throw some mud tires on ;)
  4. P

    Temp Probe for DCC controler...

    Instructions seem to indicate that the probe should be on the bottom of the rad, on the drivers side. I had placed mine on the passengers side. After moving it my car seems to get above 225F now /w a 180F therm... didn't have problems with it overheating before. Where did everyone else...
  5. P

    Mark VIII fan install comments

    Just hooked up my mark 8 fan /w dcc controller. Thought i'd chime in for anyone else having problems that is searching. install comments: I mounted my overflow tank on the otherside of the fan (passenger side), as I had to slide the fan all the way to the drivers side to make it clear...
  6. P

    How to tell calibration on C&L mass air meter

    Picked up a C&L mass air off ebay, said it was 73mm tuned for 19lbs injectors. I measured it and it's 76mm on the smaller side of the mass air. Is there any way to tell what size the injector? I don't want to just throw it on if it will cause an extreme lean condition and burn my pistons...
  7. P

    spintech pro streets quiet?

    I just installed bbk long tubes (cermaic), bbk h-pipe /w high flow cats, spin tech pros treets and flowmaster tails... going from a 2 1/4 prev setup /w offroad hpipe (custom made etc) and flowmaster 40's. I remember the 40's being a lot louder... especially at idle. Anyone else have pro...
  8. P

    Correct header gaskets

    Ordered Mr Gaskets Copperseal #7160 gaskets for my new bbk long tubes... back of the package says it's for years 62-86, and i needed #7161 for 87-95. The ports are square, and the 7161 looks to be oval shaped... the flanges on the headers are oval at the top but flat on the side. Which...
  9. P

    Looking for a Shop in houston/tx

    Looking for a shop to bolt up my Long tubes, hpipe, and mufflers in spring or houston/tx. Looked at the headers and where they have to go... decided i'd rather pay someone to do it. Bought BBK headers, hpipe /w cats, spintech mufflers, tails, and copper gaskets /w locking head bolts. Just...
  10. P

    3" collector /w 2.5 inch mid pipe

    Wondering if you can bolt up a 2.5" x pipe to a 3" collector on the long tubes... have bassani lt to put on but having trouble finding a 3" in and 2.5" out mid pipe that doesn't have to be fabbed up (dr gas) that is catted. Would rather have 2.5" than 3" coming out of the headers (stock...