Search results

  1. L

    Ford part numbers

    does anyone know the part number for a 7 tooth speedo drive gear for a 98 mustang GT with a T45 trans? 50 resto stocks it but they dont have the complete ford number listed, and i need this now and i was goin to get it from ford.
  2. L

    will this bolt up?

    negative. you dont want an a4ld backing a 5.0 anyway.
  3. L

    Car Dying On Freeway And Power Loss

    that could be a likely cause. change the filter first, but you are probably past the point of no return.
  4. L

    AOD trans tech

    thank you soo much!!! ive hit pay dirt!!!!!
  5. L

    AOD trans tech

    the link doesnt work. i should say the site.
  6. L

    AOD trans tech

    hmm i was thinking of getting a tci valve body anyway. well on the car that i tested, i know the ring and pinion messes up the governor and thats what messes up the shift points, so next car i do will be no lower than 3.55s. oh well i guess more searching for me. thats what sucks about doing...
  7. L

    AOD trans tech

    does anyone know anything about the aod? i have built one with the wide ratio 4r70w gearset, and the coupe in which its installed has a 4.10 ring and pinion. problem is that it doesnt stay in second gear long enough to take advantage of the available power. all other gears are fine. is there...
  8. L

    School me on Caster/Camber Plates

    if you want to go as cheap as possible, then have the alignment shop elongate out the stock shock tower holes as long as your negative camber isnt too extreme.
  9. L

    forever asked question

    they make 17 inch ponies too. ive seen them before, i just dont know where.
  10. L

    Mileage for SD vs. MA.

    i would definately go with a maf conversion if you plan on doing heads cam and intake. if you dont im willing to bet your car will buck, jerk and run really rich. besides, you wont see an improvement with or without maf within the first month of the new combo, (or however long it takes to get...
  11. L

    forever asked question

    it sure is. i dont even think they make 13 inch rotors with a four lug pattern anyway. if you want four lug so bad with 13 inch rotors, you might (but not likely) be able to use a focus hub with a sn95 spindle and bearing. (youll have to press out the bearings, and thats if they are the...
  12. L

    AOD question(s)

    the trans wont shift into fourth at wot anyway. just get an aode band and the afforementioned A plus servo.
  13. L

    aod rebuild stuff

    i would probably go to the dealer and get an overhaul seal kit too unless the trans shop is supplying one of those. even so i would insist that they only use ford seals. if they dont, get your own seal kit. kevlar od bands are nice, that is if you have an all out race car. the AODE...
  14. L

    swapped explorer intake on, runs rich/bogs, please help!

    is it just me or does it seem like a 65 vs a 60 mm tb and an upper and lower intake that flows wayy more than stock would require maybe a small bump in fuel pressure? i would probably put an adjustable fpr and bump it up a few (3 or so) psi then reset the computer and see where you stand. you...
  15. L

    Fuel Pump Replacement

    hopefully you dont have that much fuel in the tank, so its light and less of a chance of dropping it from the jack. what you might want to do is like stated before, definately get a new filler neck grommet, and if you get just the pump, get a new o ring seal which seals the fuel pump access...
  16. L

    5 lug question. Will 3.8 '94 parts work?

    and you can still bolt it up if you want!:lol:
  17. L

    2000 Mark DOHC engine?....with pics.

    3.9s have some get up and go, but i think you would have to run the 5r55w that comes bolted to them stock. anything is possible with enough money and will power.
  18. L

    Watch out for this guy!!

    the car is in connecticut!! its bound to be rusty. he should show some pics of the hatch area, and some pics with the wheels off so we can see those cast iron calipers and drums fared. very clean legit car though on the inside. if i were a lottery winner i would buy it just to have it.
  19. L

    quick converter question

    if the converter is completely dry, yea you can add about a quart, or a little less just to get the clutches wet. dont add any more because if you do, its just goin to spill all over the place when you are trying to spline it to then input shaft.
  20. L

    Rear Wheels Noise (Clicking)

    i had a ticking sound coming from my rear end right after i put on my five lug drum conversion. turned out to be a warped drum. it only happened when i would apply the brakes. if you want to isolate the rear brakes, use the e brake.
Top Bottom
Back
Forums
Menu