Search results

  1. RDF 01

    cleaning your Mustang

    I always use WD-40, works great, believe it or not, I also use it to prevent rubber from sticking @ the track, just a quick spray- count to ten and wipe off
  2. RDF 01

    What Will Happen If I.....

    I can vouch for this first hand, I did the E/cam and GT-40 heads on my 88 SD and the car would not idle at all, ran bad and was a hard start, so I had to change to mass air. You should leave the cam alone and do intake & exhaust- maybe even 1.7 rockers. I've heard of lots of people running very...
  3. RDF 01

    What Will Happen If I.....

    That t.b. would be way too big, you would loose power for sure, I'm running GT-40 intake & heads E/ cam, 73mm maf & complete exhaust on my '88, and I think my 70mm is too big- I felt a noticeable loss in low rpm power. You're better off buying a good MAF, thats the bottleneck.
  4. RDF 01

    High Pitch Sucking sound

    You could try spraying around the intake with starting fluid, then pay attention and your rpm will go up when the fluid is pulled into the leak-you will know the general area of the leak then. Be careful with this -it should be done with a helper holding a fire extinguisher just in case.
Top Bottom
Back
Forums
Menu