10.5's with Baer

[296blackstangs]

It's official 10.5 deep dish bullits dont fit the 13" rear baer brake kit They go on a little ways but as the wheel tapers toward the front the calipers hits the side of the wheel. So my question is should or could i buy wheel spacers to bump out the hub mounting surface so the calipers wont hit ( the gap where they sart to hit is not big maybe 3/4" from the back of wheel to current axle surface) Is this safe for drag racing, which i would be doing a good bit of? Any other suggestions (and i dont want to take off and switch my rotors)

Thanks

 

[squares98]

Get rid of those worthless rear brake rotors, and get the real Baer 12" 1 piston rear caliper brake kit, or throw the stock rotors back on.

 

[jasonh_86]

+1

I honestly don't see a reason to have 13" in the rear, but that's just me. I know I wouldn't do it with mine

 

[296blackstangs]

i kind of like the looks with 13" all the way around lol...u guys would too probably if u see them but no one does it seems like

 

[tomustang]

i kind of like the looks with 13" all the way around lol..

then get 18's