13.46@ 103mph

[ucanbeatme]

Cobra intake
75mm throttle body
76mm mass air meter
gt40 iron heads
forged internals
ford racing x303 cam
msd 6a ignition
t-5 trans
centerforce clutch
full exhaust

What horse do you think? This motor is in a 1990 vert.. I just bought it.. The guy who i bought it off of said that he ran a best of 13.46 and 103mph. Thinking about get 100 shot of nitrous.. Do you think that will get me into the 12's?

 

[94gts]

Thinking about get 100 shot of nitrous.. Do you think that will get me into the 12's?

Yup

 

[Paul Perreca]

not bad times, is that street tires?

 

[ucanbeatme]

sumatuma tires..

 

[Daniel50]

you might be able to pull a an eleven out with slicks, 100 shot, and one heluva a launch

 

[Daniel50]

also that cam may be a little much for those heads

 

[ucanbeatme]

I have 373 gears now .. do you think that i will get a few tenths switching with 410's..?? I just installed lakewood 70/30 struts, new rotors, and brake lines today. What rear suspension do you suggest?

 

[1BAD93LX]

I think that is about right for those mods, But I think the combo is maxed out as far as the time is concerned,You might get it to run 13.30s maybe, But a convertable is a heavy car.

 

[BaXTeR3221]

Thats a lot of cam you have for that combo. If you had it matched a little better you'd have better results, but i'd bet slicks and a 100 shot would get you really close to 11's.

 

[Paul Perreca]

so if he had a lower lift cam, he'd get more out of it?? I guess its not just all the best parts, but its the parts working with eachother that makes the power....

Paul Perreca

 

[NUTCASE]

so if he had a lower lift cam, he'd get more out of it?? I guess its not just all the best parts, but its the parts working with eachother that makes the power....

your entire engine is a 'system' per-say and all the components have to be able to work as a team. so a super big top end cam on say stock heads and an intake that can't go over say 5500rpm won't get you very far