2 1967 ford mustangs*1 to build 1 for parts

Status
Not open for further replies.

mrhaney

New Member
May 25, 2007
0
0
0
Hello, I have for sale 2 1967 ford mustangs...i have most parts to make a V8 clone car with parts/scrap left over that could probably be sold for at least $1000 or more....my intentions were to build a V8 car and switch the 3 speed manual to a 4 speed manual .....my wife just informed me she is buying a new 45th anniversary 2012 camaro for me for my 50th birthday ...ive lost interest so this project has to go to make room in my garage......i bought the green one to restore....it needs complete floor panels, interior, quite a bit of metal work in the front and one side of the front frame section, the rockers seem to be good and i believe most of the back frame is good..it is a factory 6 cyl , 3 speed manual car...the guy that owned it parked it in a barn 25 years ago and it was running then...it can probably be started with some soaking,points,plugs, gas etc....ive already removed the old fenders, front end,carpet etc, basically have it stripped down ready for engine/transmission removal to start the metal work......then i bought the blue car which is a 289 automatic with rare factory air conditioning that has been restored probably within the last 5 years or so and has been T-boned on the passenger side door pretty hard and is only usable for parts.....i believe it has most parts that can be used to build the other one including the metal that can be cut out to patch the other one, gas lines,brake lines,gas tank, floor boards etc....has a decent black interior with a decent console and floor shifter.,carpet and headliner can be used, 5 bolt rear end, rear springs,5 bolt hubs in front and springs for the V8 ...i also have a good passenger door in primer that i bought off of another 67 that can be used.....i believe parts that still will be needed , are front and rear bumper,passenger side fender and passenger side quarter panel...quarter panel off of driver side blue one may be able to be used ..i dont have very good pictures because i have them in my garage that is pretty full at this time..i also have a brand new plasma cutter still in a unopened box that i bought to do this restoration that i will sell for $300(paid $400) to whoever buys the mustangs....cars located in frankfort indiana.........selling for $3700 firm...i am not interested in selling parts off of either one..selling them both for 1 money.......765-659-2499 or 765-413-8801
 

Attachments

  • P1017390.JPG
    P1017390.JPG
    70.9 KB · Views: 155
  • P1017392.JPG
    P1017392.JPG
    73.6 KB · Views: 155
  • P1017388.JPG
    P1017388.JPG
    73.1 KB · Views: 154
  • P1017385.JPG
    P1017385.JPG
    76.1 KB · Views: 141
  • P1017383.JPG
    P1017383.JPG
    76.2 KB · Views: 159
  • Sponsors (?)


Status
Not open for further replies.