# 3 Spark plug.

Discussion in 'SN95 4.6L Mustang Tech' started by Bob Byrd, Sep 2, 2008.


  1. Bob Byrd

    Bob Byrd New Member

    Joined:
    Nov 17, 2002
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Outerbanks, NC
    I have just changed all the plugs on my 96GT but number 3. The plug wrench will not go over the spark plug in #3.cylinder. Am I missing something? Is a special tool required? Thanks Bob:nice:
  2. bdcardinal

    bdcardinal tree hugger

    Joined:
    Jun 10, 2003
    Messages:
    3,746
    Likes Received:
    12
    Trophy Points:
    69
    Location:
    santa barbara, CA
    no its the same as all teh other plugs. what kind of socket are you using?


    Sponsored Ad

  3. 98COBRA281

    98COBRA281 Active Member

    Joined:
    Nov 25, 2007
    Messages:
    1,457
    Likes Received:
    27
    Trophy Points:
    49
    Location:
    Port St. Lucie, Florida
    i had the same problem, but not on my car, it was on the motor i took my heads off. (that are now ported & polished) i had to beat the socket on the plug to get it out, there was alot of crud down there, if i remember right i was the driver side second one from the front
  4. bdcardinal

    bdcardinal tree hugger

    Joined:
    Jun 10, 2003
    Messages:
    3,746
    Likes Received:
    12
    Trophy Points:
    69
    Location:
    santa barbara, CA
    it could have coolant that rusted in there. wait until teh motor is stone cold and try to spray some pb blaster in there to loosen things up.

Share This Page