I am replacing my engine this winter and will be parting out my old engine after I pull it. In the mean time, I though I would see if anyone wanted the whole engine from carb to oil pan / fan to flywheel. It's still in the car, so you can see it run if you are interested. The bottom end has over 100K miles, the top end was reworked less then 10K miles ago. The block is a '68 - 302.
- Edelbrock Performer 600 cfm Carbuterator w/ elect. choke - $175.00
- Edelbrock Performer RPM Aluminum Intake Manifold - $100.00
- Edelbrock Victor Series Water Pump - $50.00
- Cobra Aluminum Valve Covers - $50.00
- GT-40 iron cylinder heads rebuilt and upgraded (not GT-40P's) - $500.00
- Complete with Comp Cams springs
- Crane 1.7 roller rockers - $100.00
Take the whole engine for $800.00, including:
- TRW forged pistons - L2305F-030
- Comp Cams High Energy 268H cam
- Milodon Oil Pan w/ Windage Tray
- High Volume Mechanical Fuel Pump
- Flex Fan
- Accel Electronic Distributor, Plugs and Wires
I'm located in Vienna, Virginia, right out side the Washington, DC beltway. I will not ship.
Thanks,
Tim
- Edelbrock Performer 600 cfm Carbuterator w/ elect. choke - $175.00
- Edelbrock Performer RPM Aluminum Intake Manifold - $100.00
- Edelbrock Victor Series Water Pump - $50.00
- Cobra Aluminum Valve Covers - $50.00
- GT-40 iron cylinder heads rebuilt and upgraded (not GT-40P's) - $500.00
- Complete with Comp Cams springs
- Crane 1.7 roller rockers - $100.00
Take the whole engine for $800.00, including:
- TRW forged pistons - L2305F-030
- Comp Cams High Energy 268H cam
- Milodon Oil Pan w/ Windage Tray
- High Volume Mechanical Fuel Pump
- Flex Fan
- Accel Electronic Distributor, Plugs and Wires
I'm located in Vienna, Virginia, right out side the Washington, DC beltway. I will not ship.
Thanks,
Tim