351 under stock 94 hood

[gt-351]

Hey everyone just looking to see if anyone has a 95 with a carbed 351 and a stock hood. I know all about the Cobra R's But I want to look bone stock. I have a Wieland stealth intake and a 750 Demon carb H.P.M 3/4 lower motor mounts and a QA1 K-member.
I also was wondering about how to use the stock tach with MSD ingnition and coil? I plan to use a msd distribtor too. Thanks for the help.

 

[95Cobra302]

I'm pretty sure with the drop mounts it will fit. I have a carbed 351 in my 86 GT and it fit with the stock hood. Not sure about the stock tach and MSD though.

 

[GTPhreak]

might barely fit if you dont run an air cleaner

 

[VibrantRedGT]

My upper intake rubbed on the inner hood liner with the stock motor. I would say maybe not.

 

[ProKiller]

with those mounts and the k-member, i would think its gonna be close.

 

[go-stang5.0]

I dunno of anyone fitting a efi 351 under a stock hood good luck with a carb 351....

 

[Scott_95GT]

Sounds like a tight fit to me. Best bet would probably be to figure out the smallest cowl that would work. Have fun with that 351!

 

[jetuomi]

well I can tell you this much with the 351W I'm putting in my car this spring I had to go buy a new hood there was no way it was going under the stock hood with a VICTOR EFI intake with a 3/8 spacer.. and definately not with a trickflow box intake w/ 1inch heat spacer.. I'm getting a 2.25 inch cowl hood that'll clear it all w/ 1 inch HPM solid drop motor mounts.. (with room to clear)..

as for carb, I don't know how that measures up.. good luck !!

 

[baglock1]

Run dry sump plumbing and custom drop mounts and you'll have tons of room.