4.6l Gt Block With 4v Heads

Discussion in 'SN95 4.6L Mustang Tech' started by Grigory, Jun 25, 2013.

  1. Grigory

    Grigory New Member

    Joined:
    Jun 16, 2013
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    Howdy,

    Question for you mustang folks.. starting a car project basically starting the car from scratch. Couple questions regarding a few components I want to swap around:

    - Will a 4.6L engine block work with 4V cobra heads?
    - If I get a bored out 4.6L block (new 5.0L from ford racing), will the heads fit on those as well?

    I guess my only question is in regards to the 4V cylinder heads bolting up. I shouldn't have any issues with the remaining forged components going into this beast.

    Thanks for the help!
     
    #1
  2. Nightfire

    Nightfire Mustang Master

    Joined:
    Dec 2, 2002
    Messages:
    3,606
    Likes Received:
    134
    Trophy Points:
    93
    Location:
    TX

Share This Page