86 4cyl to EFI

Discussion in 'Fox 5.0 Mustang Tech' started by bud168, Dec 29, 2003.


  1. bud168

    bud168 Founding Member

    Joined:
    Aug 8, 2001
    Messages:
    159
    Likes Received:
    0
    Trophy Points:
    17
    Location:
    Oxford, PA
    I have a buddy who has a 86 4cyl that he has put in a Fuel Injected 302... Motor, trans, rear, exhaust, fuel lines and fuel tank are all in place. Computer Harness and computer has been replaced with an A9L computer. I have done a couple of these conversions myself but not on a 86 and under.. the 4cyl wiring is in place and this is where we are running into some issues with not knowing what to tie into. Does anyone have any tips on what needs tied into or a website that has some conversion detail.. I have looked but came up with no luck on this type of conversion..

    Thanks for your help!!!!
    Kurt
  2. DirtyD916

    DirtyD916 Active Member

    Joined:
    May 25, 2003
    Messages:
    1,052
    Likes Received:
    0
    Trophy Points:
    36
    Location:
    Norcal 916
    type it in the search mode on the homepage of stangnets.com. There are many who have done it before. Its actually a very common conversion but things such as a new wiring hareness, exhaust, the motor itself, beefier suspension, new tranny, and a few more tidbits are needed. If i were you i would just install a nice 408 Windsor and be king of the streets.


    Sponsored Ad

Share This Page