9" Built Rear End

Discussion in 'Drivetrain Parts' started by Jakencub, May 14, 2011.


Find More Mustangs For Sale!

  1. Jakencub

    Jakencub New Member

    Joined:
    Oct 1, 2003
    Messages:
    44
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    De/Md line near the beaches
    This is a complete rear end built up for a 1996 Ford Mustang. I had it installed in my stock Mustang for approx 250 miles. I had planned on building the car up, but before I could continue, I had to remove it to get rid of the car. The miles were all street miles, no track. I am looking to get just the cost of the parts back. I am wanting to sell it complete, brakes to brakes if possible. Total cost to install and then remove was over $5000. I am looking for $4000 or trade for salvageable SRT-4 Neon.

    Build List:

    9" Ford Housing
    - 33 spline axles and 5/8" studs
    - Aluminum Center Section with 1350 yoke, 3.70 gears, full Spool

    Aerospace Components Rear Brake System
    UPR Control Arms w/ Spherical Bearings
    Moroso Springs (47510-100)
    QA1 Shocks
    SS Brake Lines

    [​IMG]

    [​IMG]

    [​IMG]

    [​IMG]
     
    #1
  2. leasureryan

    leasureryan New Member

    Joined:
    Apr 25, 2011
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    OHIO!
    price???
     
    #2
  3. Jakencub

    Jakencub New Member

    Joined:
    Oct 1, 2003
    Messages:
    44
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    De/Md line near the beaches
    Sorry, post has been updated with price.
     
    #3

Share This Page