9" housing w/Martz Chassis 4link brackets

Discussion in 'Engine and Power Adder' started by Travis77, Feb 4, 2009.

Thread Status:
Not open for further replies.
  1. This is a rear housing that I ordered from Martz Chassis (3 months ago)that came with their parallel 4 link kit. Everything is heavy duty and all welds look great. The reason I am selling it is because I was originally thinking I was going with a much lower ride height which would have required a narrower track width. Things have changed and I plan to start from scratch. The housing is 48.5" from flange to flange. It is made for a center pinion yoke. The axles are moser 31 spline. It is coated in self etching primer. I am asking $525. Thanks

    View attachment 272577

    View attachment 272578
     
Thread Status:
Not open for further replies.