95 5.0 to 96 V6

Discussion in '1994 - 1995 Specific Tech' started by soldier42486, Dec 28, 2012.

  1. soldier42486

    soldier42486 New Member

    Joined:
    Dec 27, 2012
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    Butler, MO
    I recently traded my 77' El Camino for a 1996 Mustang. It's a V6 car that has been converted over to a 5.0 that came out of a 95 Mustang. As far as I can tell everything has been done correctly and I was told it was but you know how that goes. So my problem is...it's loading up bad. Pushing so much fuel through that it sometimes kills the engine at an idle. Now I don't know a whole lot about the 5.0 conversion. My question is why is it loading up so badly? Is it a sensor? Bad computer? Was the conversion not done correctly? Any suggestions are welcome.
     
    #1
  2. 94mustangcobra

    Joined:
    Sep 30, 2006
    Messages:
    126
    Likes Received:
    0
    Trophy Points:
    16
    Location:
    Valdosta, GA
    You're going to have to be specific about your setup...injector size, MAF size, ignition system, fuel pressure regulator, fuel pump, etc etc.
     
    #2

Share This Page