96 Mustang Doesn't Continue Running

[Duffman14]

Recently I was driving my 1996 2.3L Mustang when I rear ended the car in front of mine. Well after a while I began working on it, replacing the damaged parts- radiator mount,radiator, bumper etc. The other day I decided its been sitting a lil too long so I attempted to fire it up, it started but only ran for a short time with a loud exauhst and shaky engine. If I did shift it into drive the engine bogs and stalls. So I borrowed a friends scanner to see what the problem could be and this is what I got. The CAT,EGR,HRT and O2S all indicated failure using the scanner. Any help would be much appreciated.

 

[madspeed]

Welcome to stangnet. I've moved your post to the appropriate forum where you'll find some help!

Good luck

 

[madspeed]

I'll assume you have a v6, there was no 2.3 engine available after 1993

 

[Duffman14]

Yes, my bad I was thinking of my other car

 

[Mustang5L5]

Did you run the engine after replacing the parts? I would bet you have a harness disconnected in the engine bay

 

[Duffman14]

I have found no harness disconnected in the engine bay, any other possabilities?