AMp wiring questions, for power source.

[roush 97]

I wanted a bit more punch to my speakers so I hooked my amp up to them. I wired the remote turn on up to where it's supposed to go on the back of the reciever. I hooked the constant power up to the battery, (I used a fuse link at the battery too). Well, the amp works fine, till I start the car. Then I can tell my ignition system is fine since I can hear it over the music comming out of my speakers. What do I need to do to stop the noise? Is there a different power source that would help other than directly to the battery, or is there some other means? Thanks for the help.

 

[Pertums]

Give this a read it might help you out.. I had some engine whine too in my truck and this fellas post saved me the headache of figuring out what to try next, etc..

http://forum.sounddomain.com/forum/ultimatebb.cgi?ubb=get_topic;f=5;t=008251#000000

Good luck...