Any ideas before i shoot my stang!!

[Cheyeter]

thats great info, thanks hissin50

 

[Cheyeter]

Just wanted to say Thank You! all for helping me out with my trouble.

 

[gcomfx.com]

A stock M/A meter is pricey (I'll sell you mine), but cheaper than getting rid of a mustang with bullet holes all over it.

 

[GTA_V6_Mustang]

A stock M/A meter is pricey (I'll sell you mine), but cheaper than getting rid of a mustang with bullet holes all over it.

Now may I ask, what are you doing with a mustang full of bullet holes??

 

[Cheyeter]

haven't shot it yet, but i have been dieing to shoot something with my new toy!

 

[HISSIN50]

Definitely getting a used meter or tossing one on from a local guy (for a test drive and testing) is the way to go.

 

[Aliate X]

do the foxbody MAF's work for the sn95's?

 

[Cheyeter]

i have know idea if they interchangeable

 

[HISSIN50]

The fox meters (non Cobra) work but are 55 mm. YOu just need to adapt the fox meter's flange to fit (you need to swap the entire meter. You cannot put the fox sensor in a 94-95 housing).

 

[gcomfx.com]

Now may I ask, what are you doing with a mustang full of bullet holes??

LOL Read the title of the thread.

 

[Cheyeter]

what are the specs. of the MA meter?

(b+) + gnd @ harness w/ koeo? mine .955

Sig + gnd @ harness w/ koeo? mine -1.836

pcm + gnd @ harness w/ koeo? mine -1.854

MAF sensor not connected

(A= b+) (B=PCM) (C=gnd) (D=sig)

A - C = 4.85m ohm's
B - C = .001 ohm's
D - C = 4.19k ohm's

probly no big deal just would like to know

 

[HISSIN50]

I'd double check your VPWR to the meter.

 

[Cheyeter]

What do you mean by VPWR??

 

[HISSIN50]

You should have 12 volts feeding your MAF with the key on. The power is supplied by pins 12 and 24 of the CCRM (EEC relay output).

 

[Cheyeter]

when i go sig to b+ i get 12.43v

 

[HISSIN50]

(b+) + gnd @ harness w/ koeo? mine .955

when i go sig to b+ i get 12.43v

I think I must have misunderstod you.

When you probe the power feed to the MAF (key on), and have the other DMM lead grounded (to anything), it should read 12 volts.

I had the impression this was not the case in your first quote above.

You probably have an EVTM but here's a diagram anyhow.

 

[Cheyeter]

It was the Mass Air meter, i picked one up at oreillys for 69.00 dollors. Plugged it up and she fired off and idle and ran good. Thaks to all for your help.

 

[rj95svt]

I'm glad you got her up and running!

 

[HISSIN50]

 

[gcomfx.com]

It was the Mass Air meter, i picked one up at oreillys for 69.00 dollors. Plugged it up and she fired off and idle and ran good. Thaks to all for your help.

:SNSign: Very good news. Congrats....