Anyone have info on new BBK intake?

Discussion in '1994 - 1995 Specific Tech' started by Killercanary, May 1, 2003.


  1. Killercanary

    Killercanary The car that set the bar.
    Founding Member

    Joined:
    Nov 30, 1999
    Messages:
    5,725
    Likes Received:
    1
    Trophy Points:
    76
    Location:
    Altoona, PA
    I saw on Hot Rod TV that BBK is making a fuel injected intake manifold that is similar to the air gap carb intake by edelbrock. It looks like a great design, but I can't find info anywhere on it. I searched their site and found nothing. The intake looks very high though which may cause issues with hood clearance on our low-profile ones. If anyone has info let me know...
     
    #1
  2. OinkAodeOink

    Founding Member

    Joined:
    Jun 5, 2002
    Messages:
    3,034
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Daytona bch, Florida
    i think i read about it in one of the mags recently.. check MM&FF or 5.0 Mustang. Could have sworn i read about a new intake.
    And i dont mean the Edelbrock RPM II
     
    #2
  3. Venom351R

    Founding Member

    Joined:
    Apr 27, 2002
    Messages:
    13,944
    Likes Received:
    37
    Trophy Points:
    98
    Location:
    MAINE
    first time I heard of it, but new products are always good, if anyone finds anything on it post it.
     
    #3
  4. Killercanary

    Killercanary The car that set the bar.
    Founding Member

    Joined:
    Nov 30, 1999
    Messages:
    5,725
    Likes Received:
    1
    Trophy Points:
    76
    Location:
    Altoona, PA
    Bringing back an old post from the dead. I noticed this intake on the HOT ROD TV show in the background of one of their shots. I couldn't find anything on it... now months later it is in 5.0. It looks like a very good design, I might have to try one out!!!
     
    #4

Share This Page