Blowing fuse(18-20A)

Discussion in 'SN95 V6 Mustang Tech' started by Stephens_94-3.8_stang, Jan 5, 2013.


  1. Stephens_94-3.8_stang

    Stephens_94-3.8_stang New Member

    Joined:
    Jan 5, 2013
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    1
    Hello. I'm in the final stages of replacing my head gaskets. I replaced all gaskets and now im all put together but i keep blowing fuse 18, 20a.
    Replaced coil and wires, now im on my way to the junk yard to find a new ignition module cause i steped on it. seems to work but its cracked now so il lreplace that. everythng works until i plug in the coil. Please help
  2. kramer

    kramer Member

    Joined:
    May 8, 2012
    Messages:
    76
    Likes Received:
    1
    Trophy Points:
    8
    Location:
    stonewall oklahoma
    maybe you have a plug wire thats been eaton into by heat and its shorting **** out , i dont know dude
  3. Stephens_94-3.8_stang

    Stephens_94-3.8_stang New Member

    Joined:
    Jan 5, 2013
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    1
    Figured everything out!
    Thats right along the lines of what I was thinking, so I did some back tracking to find my problem and I found that the coil and the crank shaft sensor plugs were swopped. My help was just plugging wires in where they fit, so i swopped them back and she ran perfectly. Thanks for the tip.

Share This Page