1. John Dirks Jr

    John Dirks Jr Active Member

    Joined:
    Jun 28, 2013
    Messages:
    523
    Likes Received:
    50
    Trophy Points:
    39
    Location:
    Maryland
    Here's my bubba body shop repair. Prior to my attaining this car, someone had pulled it by the rad cor support and bent it forward. I used a Come-Along anchored to the rear suspension to pull it back. I guessed that it would not take too much effort to pull it back and I was correct. Not perfect but effective and good enough for me. Below are before and after pics.

    [​IMG]

    [​IMG]
     
    #1
  2. Grabbin' Asphalt

    Grabbin' Asphalt Mustang Master

    Joined:
    Jun 11, 2013
    Messages:
    1,940
    Showcase:
    25
    Albums:
    1
    Likes Received:
    277
    Trophy Points:
    94
    Location:
    Atlanta, Ga
    Nice work, way better than i thought it was going to look.
     
    #2
  3. John Dirks Jr

    John Dirks Jr Active Member

    Joined:
    Jun 28, 2013
    Messages:
    523
    Likes Received:
    50
    Trophy Points:
    39
    Location:
    Maryland
    Thanks. BTW the bumper cover was also previously turned slightly upward. After pulling the support back into position the bumper cover settled back to its normal position. The support is flat across the bottom too. I'm happy with it.
     
    #3
    Grabbin' Asphalt likes this.

Share This Page