comp cams pi swapped piston clearance?

Discussion in 'SN95 4.6L Mustang Tech' started by lman657, Dec 12, 2003.


  1. lman657

    lman657 New Member

    Joined:
    Aug 31, 2003
    Messages:
    85
    Likes Received:
    0
    Trophy Points:
    0
    Hi guys, I'm looking at putting comp cam's XE270AH camset for my 4.6 headswap project, and i'm wondering if the valves clear the pistons with the larger compression ratio? I called comp cams, and the guy on the phone told me "figure that one out on your own..." I wasn't too impressed. Anyways, who is the best (mind you, I can't spend too much) at burning me a chip to correct my idle and account for my mods, which are to include L/T headers/ P&P PI heads/Prochamber.

    Thanks!

    lance
    #1
  2. 1sweetGT

    1sweetGT New Member

    Joined:
    Aug 31, 2001
    Messages:
    309
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Voltron Defenders of the universe!!!
    Nice choice on the cams. I can't awnser the clerence question for you (I would probably say no clerence problems) but as far as the chip I would go with a custom Dynotune. Especially with your set up.
    #2

Share This Page