Complete 2V Engine/Tranny Extras

Discussion in 'SW Classifieds' started by supersexy00GT, Mar 15, 2006.

  1. supersexy00GT New Member

    Member Since:
    Jan 5, 2006
    Message Count:
    5
    Likes Received:
    0
    Trophy Points:
    0
    From the CAI back to the X pipe: 2000GT
    - C&L CAI 80mm ma
    - Accufab 75mm TB
    - Comp Cams
    - Steeda UDP
    - BBK long tubes w/ o/r X-pipe

    - T-45 with 4,000 (four thousand) miles after Standard Gear and Tranmission in Fort worth TX rebuilt it.
    - Steeda Short Throw shifter
    - RAM dual friction clutch
    - RAM alluminum flywheel

    The motor (windsor) is still in the car until i do my swap or someone wants it. preferably assembled, however, i will part it out if someone desides to buy the bulk of it first. Welcome to drive the car and see it run if your'e local. NOTHING but royal purple has been run in this motor, its very strong, good compression, etc. The tuning was done by Mike Wilson at Dallas Mustang and the numbers were 289/298 before the tranny, clutch, flywheel, and UDP's were installed. 100k miles is the downside to this, but like i said, it does have lots of life into it, as the valves were reworked when the cams were installed @80k.

    email- brkrukiel@hotmail.com
    phone- (817) 673-8783
    or just pm. email is best though.
  2. Outlaw97GT New Member

    Member Since:
    Sep 11, 2005
    Message Count:
    276
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Redneckville, Tx
    How much for the complete engine?
    And for the heads/cams seperate?
    Where are you located?

Share This Page