COP Resistance

[bullitt 736]

Can someone tell me the coil ohm resistance ranges for the primary and secondary resistance on a 99-04 COP?

My secondary resistance on one coil I checked was 6.0. I know the primary should be a lot less but my digital meter doesn't go low enough. I plan to pick up another one tomorrow.

Thanks

 

[Brute03]

i think secondary should be around 5.5K ohms and the primary should be .55 ohms or something like that, but when i tested my new coils i couldn't get those numbers so go figure

 

[Kilgore Trout]

http://forums.stangnet.com/showthread.php?t=604123&highlight=primary+resistance

 

[bullitt 736]

Thanks for the replies. I managed to pick up a Haynes manual on the way home today.

As I said earler the secondary on one coil I checked was 6.0. I assume this is defective and that there is no +/- on the spec. Is this correct.

I will get the rest checked this week.

Thanks again.