Exhaust Correcting Low Hanging Magnaflow Ca Cat

Discussion in 'Fox 5.0 Mustang Tech' started by bruno, Jul 9, 2014.


  1. bruno

    bruno Member

    Joined:
    Mar 8, 2003
    Messages:
    36
    Likes Received:
    0
    Trophy Points:
    7
    Has anyone with magnaflow x-pipe CA cats (#337338) had a muffler shop modify the lower hanging passenger side? That side hangs low enough that it often gets scraped over speed bumps. My mech and I took a look at it on the lift and there doesn't seem to be enough space to place the cat higher toward the engine; between the engine and chassis. And if we place the cat further down, it might be too close to the oil pan. We were worried about heat off of the cat effecting the oil temp, is that a reasonable concern?

    If anyone could post a picture of how they’ve rerouted that cat it’d be greatly appreciated.

    Thanks in advance,
  2. bruno

    bruno Member

    Joined:
    Mar 8, 2003
    Messages:
    36
    Likes Received:
    0
    Trophy Points:
    7

Share This Page