Engine bay dimensions after panel repair

Discussion in 'Classic Mustang Specific Tech' started by Terry Byrd, Jan 5, 2013.


  1. Terry Byrd

    Terry Byrd New Member

    Joined:
    Dec 31, 2012
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    1
    I repaired my cowl vents and replaced a section of the firewall and now my driver side fender will not line up to the mounting holes along the engine bay. These are replacement NOS fenders and everything else lines up fine.
    Can someone with a 66 give me the measurements from the inside of the fenders and also from the engine bay at the hood hinge to hood hinge?
    This would be a huge help.
    #1

Share This Page