- Jan 20, 2014
- 5
- 0
- 2
Hey guys,
Looking for some advice. Bought a motor from a guy who said he had it all setup but not assmebled.
So bearing clearances, rings, balance are all done.
My issue is that the counterweight is hitting the bottom of the piston before BDC. Before I take it to the machine shop do you think this can be fixed or am I going to be looking for at a minimum a new crank/rods?
Looking for some advice. Bought a motor from a guy who said he had it all setup but not assmebled.
So bearing clearances, rings, balance are all done.
My issue is that the counterweight is hitting the bottom of the piston before BDC. Before I take it to the machine shop do you think this can be fixed or am I going to be looking for at a minimum a new crank/rods?