Ford 9" by Chassis Works ~New~ 300$ ~ strong and ready

Discussion in 'Drivetrain Parts' started by rwkhaus, Jun 6, 2011.


  1. rwkhaus

    rwkhaus New Member

    Joined:
    Jun 6, 2011
    Messages:
    0
    Likes Received:
    0
    Trophy Points:
    0
    http://www.cachassisworks.com/p-730-...s-3-tubes.aspx

    The above without ends on it. It is currently 65" end to end of tube.

    Complete housing is .25 wall and tubes are 3" OD.

    Has a drain and fill plug welded in. All done by Chris Alston - chassisworks.

    300$ as it sits.

    PERFECT for a Muscle Car, prerunner, jeepspeed, or crawler. Back braces and or truss can be added.

    This is all new ready to be built. I can get it built for low $ if needed also.

    [​IMG]
    [​IMG]
    Robert
    714-875-2414
    Yorba Linda CA
    #1

Share This Page