here are a couple videos of the car on youtube. the sound on the camera is not the greatest, but you should get the idea. 1967 ford mustang 289 5 speed idle with x pipe and flowmaster 40 series - YouTube 1967 ford mustang 289 5 speed break in - YouTube this is a brand new complete restoration 67 mustang coupe. it took about 1.5 years to complete, i have 100% photo documentation to show every step of the process, including the complete engine build. clean clear title in my name now has 903 miles on the odometer and the entire car. the original 289 with some serious work done, .40 over flat tops, 351 valves, original small chamber heads, thumper camshaft, weind stealth intake, dual feed 650 chrome carburetor, chrome air cleaner and valve covers and breathers, billit electronic distributor and 50k volt coil, full length long tube headers with 3 inch collectors, 2.5 inch x pipe and 40 series flowmasters, new t-5 tranny, new flywheel, clutch, pressure plate, and bearings, new custom aluminum driveshaft, 3.73 8.8 inch rearend, 4 wheel disk brakes with 12 inch ventilated rotors, and twin piston calipers, 17x8 wheels, 245/45/17 kumho tires, complete new black interior from headliner to carpet, with electro-illuminecent white face guages that changes colors, with tachometer, and calibrated speedometer, cd stereo system with remote, gt driving lights, 100% new from front bumper to rear bumper and from top to bottom. i replaced full floors, full quarters, hood, lower cowl panel, full dash, trunk lid, front and rear vallance, and front fender apron-- just to name some of the extensive work. a photo build sheet will come with the car as well as all paperwork. i have it insured for a guaranteed value of $20,000. this car is done rite. i have more invested in this car then i am selling it for. $18,000 possible trade............ call tim at 731-852-2253. leave message, this is my work phone and its the best way to reach me.