Help identifying wires?

Kevins89notch5.0

Founding Member
Founding Member
Jan 1, 2000
5,864
1
78
Trying to help out a friend...

"I've got a few ends that I can't remember where they go.

Two from the engine bay...
183387.jpg


183388.jpg


Two underneath... first one by starter...
183389.jpg


Second one on drivers side of engine...
183390.jpg


:shrug:
 
  • Sponsors (?)


third one looks like the spade connector to the starter. Its a solenoid ground if I'm not mistaken. look for a metal spade sticking somewhere of the starter. Oh and if its rusty clean it up a bit. Bad grounds are no good.
 
First one does look like the connector for the TFI module, but that's not it... I already have it connected (on the other side of the car).

Second I'm thinking is the old EGR connector, maybe? I can't find my old EGR valve to compare.

Second to last one was the ground for the starter. Got that hooked up.

The last one, I did think it went on a small stud on the block or pan. Old pan didn't have a stud on it, either.

I also am trying to figure out the routing of the vacuum line on the charcoal canister. I think I know where it goes, but I'm not completely sure.