That picture is way to small... It almost looks like the little bracket that wiring harness plugs into. if so it goes on a stud underneath your pass valve cover.
yeah, thats just a speed nut, could go anywhere...trans crossmember, rear control arms, subframe and more, any idea of the thread size? or wtf you took apart?
I've had the tranny out, the radiator, alternator, dropped the ac compressor, and pulled the intake off. I checked the thread size against my taps and it is m10x1.5
I've had the tranny out, the radiator, alternator, dropped the ac compressor, and pulled the intake off. I checked the thread size against my taps and it is m10x1.5
if I had to guess, I'd have to say somewhere around the trans as the trans to block bolks are 10mm x 1.5 and I dont sea anything around the rad, alt or a/c thats 10mm, all 8mm or 6mm
i vote its the nut that bolts on the short sway bar under the tranny. I think it goes on top of the k member and the bolt threads up through it and the wing stops it from spinning so it can be tightened.
you are right about the nut being a self tighting type or speed-nut as we call them but the "K" member bolts are 14mm....now you may have something on that secondary "tublar" crossmember, as thats 10mm x 1.5 thread