installing 8.8 in a ex 4cyl car need help with brake lines

Discussion in 'Fox 5.0 Mustang Tech' started by tnardo, Dec 23, 2003.


  1. tnardo

    tnardo Founding Member

    Joined:
    Jan 23, 2000
    Messages:
    664
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Norwalk, Ohio
    ok the rear end is in and i put in brake lines from an 8cyl car. i also bought the new rear brake line, it has a hose with a banjo bolt and a box where the hose goes into and two fittings are on the side. the rear end has both lines from each side going to a box that also has a hose comming off of it but its cut. where does the banjo bolt go how do i put this stuff together and am i missing anything
  2. tnardo

    tnardo Founding Member

    Joined:
    Jan 23, 2000
    Messages:
    664
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Norwalk, Ohio
    can i eliminate the banjo bolt and just get a t fitting and run the brake line from the front to the t then 2 each wheel cylinder


    Sponsored Ad

  3. SuperchargedB87

    SuperchargedB87 Founding Member

    Joined:
    Oct 25, 2002
    Messages:
    485
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    New Jersey
    I don't see why you couldn't eliminate it if you keep the lines secure. I believe its only function is for extra support. When I put stainless steel lines on mine, I think I left that out also.

Share This Page