Is there anyone on here that actually knows what they are talking about?

Discussion in 'Fox 5.0 Mustang Tech' started by fordman54935, Dec 10, 2004.


  1. 90Notch

    90Notch Founding Member

    Joined:
    Jan 31, 2002
    Messages:
    1,046
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Westwood, MA & yes it's killing me that I'm no
    "My car starts to fall off just over 5000 and stays steady till "

    Read some old posts and saw the larger valves, vlv job and looking at peaks guessing cam isn't installed on stock ICL either. Makes sense now, good job!

    Tom do you have or know where I can find a formula to find average under curve? Don't feel like pulling out math books.
  2. tmoss

    tmoss Gettin Wired Founding Member

    Joined:
    Jun 28, 2001
    Messages:
    7,120
    Likes Received:
    2
    Trophy Points:
    78
    Location:
    Saint Louis, MO
    I do mine by loading the rpm vs torque points in an Excel spreadsheet and let it do the average calcs. I let Excel calculate the HP from torque and I graph the end result to be sure the curves look the same as the dyno as a quality check. I also use Microsoft Paint to pull lines across the dyno sheets to get accurate data points from the graphs. I attached an example of what the graph looks like when I'm done..........

Share This Page