JDM CNC 4.6 Romeo PI heads

Discussion in 'Engine and Power Adder Parts' started by nickmckinney, Oct 7, 2009.


  1. nickmckinney

    nickmckinney Member

    Joined:
    Sep 25, 2009
    Messages:
    164
    Likes Received:
    0
    Trophy Points:
    16
    JDM CNC PI heads with only 500 miles (motor broke the bottom end right after dyno run) I have to install a Timesert into one chamber, decks will be surfaced again. $995 for the pair. They were brand new castings with 8 threads when installed on the motor. These are big dawg PI heads, some nice CNC work here. Only flaw is one spark plug thread was messed up, hence the Timesert.
     
    #1

Share This Page