Kenne bell for 07 sgt

Discussion in 'The Welcome Wagon' started by FriscoJared, Dec 7, 2009.


  1. FriscoJared

    FriscoJared New Member

    Joined:
    Dec 4, 2009
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    0
    Hello, I am new to this site and this is my first post. I am planning on installing a 2.6L kenne bell stage 2 kit on my sgt. Can anyone tell me if 10psi is too much with a street tune. Kenne bell tells me this should put me right at the limit of the stock internals. Any adivse would be greatly appreciated.
  2. sweet tooth

    sweet tooth New Member

    Joined:
    Feb 1, 2007
    Messages:
    154
    Likes Received:
    0
    Trophy Points:
    0
    HI.jared that is about all you can push on stock 2v internals,maybe 12lbs with a good tune.
  3. MeanMike

    MeanMike New Member

    Joined:
    Sep 12, 2009
    Messages:
    105
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Maine & Indiana
    I'm running the stage1 with 10psi on mine.
  4. FriscoJared

    FriscoJared New Member

    Joined:
    Dec 4, 2009
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    0
    How hard is it to just rebuild that stock 3v engine? Would'nt it be cheaper to just strip it down throw a steel crank, h beam rods and some decent piston's and rings in it and be done with it, or would the machine work end up costing more than an aluminator or sean hyland short block?
  5. LAVAgt2012

    LAVAgt2012 Well-Known Member

    Joined:
    Aug 11, 2011
    Messages:
    1,662
    Likes Received:
    57
    Trophy Points:
    58
    Location:
    Panama City, FL
    :shrug: don't know, but welcome to the forums

Share This Page