Liberty Pro Shifted Tremec Tko And Supporting Components

Discussion in 'Drivetrain Parts' started by mustang500hp, Jun 5, 2012.


  1. mustang500hp

    mustang500hp New Member

    Joined:
    Aug 11, 2003
    Messages:
    13
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    Kansas City, MO
    I have up for sale a liberty pro shifted Tremec TKO transmission 26 spline input shaft/ 31 spline output shaft. It has a mcleod scattershield to link it to a small block ford, 50 oz imbalance Ram steel flywheel, ram 900 series sintered Iron clutch and pressure plate, ford clutch fork, lakewood adjustable clutch ball, 31 spline driveshaft yoke, Pro 5.0 shifter, I will even throw in a virtually new ford clutch cable, and steeda clutch quadrant. This tranny and all components have very low use, it had about 100 miles on it before it was removed from the car, then it was shipped to liberty tranmissions and they said it looked brand new when they applied their proshift modification to it. after that it had 20 quarter mile passes on it, never powershifted. These components today would cost you at least $3500, I will sell for $2000 if you come pick it up. P.M. or Email for info [email protected]
    #1

Share This Page