longtube headers+Lowering your car

[zgarske1038]

well i want to lower my car and just recently purchased some BBK ceramic coated long tube headers i want to know how low i can lower my car with out running into clearance issues.... at one point i was looking at H&R ss's but i dont think i can even consider that with LT's so im now looking at H&R sports any one have some advice?

 

[D.K]

I'm running H&R SS springs and MAC LT headers, and I don't have many problems with ground clearance. As long as you are careful when you drive, you should be fine.

 

[stangmsy]

i am also wondering about that because i want the H&R SSs and long tubes and i want a 1.5 drop

 

[nickthegenius]

Same here, I have Mac LTs with H&Rs and they actually sit a tad higher than the UPR X-pipe I had previously. Unless the BBKs hang really low, you should be fine.

 

[zgarske1038]

thanks that made my decision alot easier

 

[StangLou]

I have the BBK ceramic coated as well and they barely stick out past the K member. I mean there is about 1/4" sticking out. I think you would be safe as long as you dont go more than 1.5" drop, preferably 1.25"

 

[GreenOOGT]

droping

Who knows how much drop I have (2+ inches). From the ground to the fender is 25 1/2in. I am running hooker l/t only time I ever hit them when I no choice but to go over a big speed bump you just have to watch for stuff.

Shawn

 

[stangman]

i have a 1 1/2" drop with longtubes & no problems what so ever