Drivetrain Looking for a GOOD Concentric Slave Cylinder - Throw out bearing

Discussion in '2005 - 2009 Specific Tech' started by 495HPGT, Apr 7, 2013.


  1. 495HPGT

    495HPGT New Member

    Joined:
    Apr 7, 2013
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    I've just pulled the OEM clutch on my 05 with 71k miles, 52k blown. Everythig still looks good, but it started slipping in 4th gear. I'm replacing it with a Centerforce DF. I've read post about bad and short life Concentric Slave Cylinder's, and would like any input on a GOOD CSC out there. Thanks in advance!
    #1
  2. Noobz347

    Noobz347 Stangnet Facilities Maint Tech... Er... Janitor Admin Dude

    Joined:
    Jan 5, 1985
    Messages:
    19,504
    Likes Received:
    2,368
    Trophy Points:
    174
    The consensus seems to be that the OEM slave is the way to go.
    #2
  3. Ranzo

    Ranzo New Member

    Joined:
    Jun 18, 2010
    Messages:
    17
    Likes Received:
    1
    Trophy Points:
    4
    That's what I've been told and the route I'm going, OEM.
    #3
  4. GoneFord

    GoneFord Member

    Joined:
    Jun 3, 2008
    Messages:
    115
    Likes Received:
    2
    Trophy Points:
    19
    That's pretty impressive. My stock clutch gave up after less than 500 miles blown for a total of 3000 miles. I wish I was so lucky.

    I too went with a stock slave cylinder. I've rolled up 26K of pretty aggressive DD. No issues.
    #4

Share This Page